DRW ARCHITECTURE BLOG

Beach House Restoration

At drw our primary focus is on designing and building new buildings, as well as additions and alterations to existing buildings. Occasionally we have been approached to do repair and restoration on architecturally interesting projects, such as the Forest Park Midcentury Modern a couple years ago. Earlier this summer, one of clients asked us to do some restoration work on their beach house, which was designed by Saul Zaik, an architect we very much admire. (There is a good essay about Zaik's work at Portland Modern.)

On the whole, the house has aged very well, but the weather at the Oregon Coast can be much less forgiving than in the Willamette Valley. As such, some of the shingles and guardrails around the deck were in need of replacement. Our team, including David, Clay, Mitch & Jacob spent the last of September's good weather working on the restoration work.

Our first step was to demo the area in need of replacement.

We then installed new plywood sheathing.

Followed by new building paper.

The next step will be to hang new shingles, which will be carefully selected to match the existing.

During the course of our work, we were very careful to ensure that we continued to respect the architectural intent of the original design. One example of this is the guardrail cap, which needed to be replaced.

The guardrail cap was cut from a 6x6 Douglas Fir post. The first step was to miter cut the whole length of the post, so that it could be installed at a 45 degree angle. We then chamfered the corners, to ensure there were no sharp edges. We also a cut a kerf for the shingles to be let in into, to create a good drip-edge. The guardrail cap will be left unstained, as the original was, so that it will weather into the same silvery-gray color that the rest of the house has.

Deschutes Residence excavation

We last wrote about the Deschutes Residence in May, after a site visit to confirm the location on the property. Since then we have completed the construction documents, and obtained the building permits.

The house is being built by CS Construction in Bend, who forwarded us these photos of the excavations. This process is necessary to get enough depth for the foundations and crawlspace, while keeping the finished floor close to the average height of the exterior grade. Although the site is reasonably flat, there is a subtle slope across the length of the house. At one end the house will be built into the slope, with the finished floor being slightly below the level of the grade outside. At the other end, the grade will be built up to meet the garage slab. Splitting this difference avoids a large number of steps on the first floor, and keeps the building close to the ground.

After spending a good portion of this year thinking about the design of the house, it's exciting to see work begin on site. We look forward to updating our blog with the progress during construction.

2014 Summer BBQ

It's been a great summer in Portland, which gave us perfect weather for our 4th annual BBQ. It's hard to believe a year has already passed since our last BBQ. As ever, it was a great opportunity for our team (who are often working on different projects across the city) to get together over beer, burgers and table tennis. Unfortunately, no-one except our boss Ryan thought to wear their drw design build t-shirt.

Alphabet Condo, update

Work is drawing to a close at the Alphabet Condo, which we posted about early last month. Since then, tile and countertops have been installed, which complement the existing architecture of the space very nicely.

Deschutes Residence

We are currently working on the design for a new house in rural Deschutes County, near Bend. The clients are good friends of drw, who we previously designed a house for when they lived in Portland.  Since then, they have relocated to central Oregon, where they recently purchased a plot of land.  They approached us last year to design a new house for the site, to replace an existing manufactured house on the site.  The design makes reference to the agrarian landscape of Central Oregon, with references in its form to the graceful barns found in the area. The 1st floor walls will be stucco, with areas of cedar siding; and the second floor cedar siding. The roof will primarily be slate, with the dormers accented in standing seam metal.

West Elevation

On a recent trip to Bend, we visited the site with the clients to stake out the location of the house on the site.

The site is surrounded by mature juniper trees to the east, which will remain after construction. To the west, the house will face onto the owner's agricultural land, with views towards the Cascades.

Westover Residence

We're delighted to have received photos of our recently completed Westover Residence Kitchen. See more photos here.

ALPHABET CONDO

Since the start of the year, we've been working on a remodel of condo in NW Portland's Alphabet District. It's a beautiful building, listed on the National Register of Historic Places. After buying the unit, our clients approached us with a number of improvements they wished to make before moving in, including a complete remodel of the kitchen and bathroom, as well as new cabinets for the living room and master bedroom.  After the inevitably messy phases of demo and rough plumbing / electrical, we've begun to move into finish work.  Mostly recently, the kitchen cabinets, built by Crownwood Construction, arrived on site, and it's now possible to see what the project is going to look like.

CHECKING IN ON THE CORBETT-TERWILLIGER HOUSE

The Corbett-Terwilliger house is coming along nicely. The exterior siding is completed and the crew has moved onto the interior trim. Cabinets are scheduled to be finished any day and the kitchen should be up and running soon. 

John basking the pacific northwest sun

John basking the pacific northwest sun

Looking Back at 2013

Skyline Residence Kitchen

Skyline Residence Kitchen

It's been another busy year for drw design build. A lot has happened since our last summary in 2012:

Corbett-Terwilliger Latest

It's a while since we last checked in on the progress at the Corbett-Terwilliger house. Since then, the majority of the exterior work has been completed, including new custom windows built by the homeowner.

The interiors are coming along nicely, and we hope to have a photo update shortly. 

Westover Cabinet Delivery

After a couple months of demolition, framing, electrical and plumbing changes to substantially increase the size of the kitchen at the Westover House, today marked the day we were ready to receive the new kitchen cabinets. They were delivered to us by our friends in Eugene, Skyline Fine Cabinets, who have also built the cabinetry for a number of jobs, including the Fairmount Blvd House and the SW Vista House.

Summer BBQ

On a day with a low of 37 degrees, it's hard to believe it was just a couple months that we had our third annual BBQ. As a company with a design office and construction crews at various different projects, we don't necessarily get a chance to see each other at work as much as we might like, and so events like these are a great way to catch up.  It was a great evening, with some very (perhaps overly) competitive ping pong matches.

Design Matters

We would like to extend a big thank you to everyone who came to see our Cable Hill House on Saturday.  We really enjoyed having the opportunity to show off our work, and are very grateful to the homeowners for being willing to give up their house for the day.

Design Matters: A Tour of Exceptional Portland Homes

Update: 10/10/2013 - The AIA Homes tour is this Saturday.  We're looking forward to showing people around one of our favorite projects.

We're very excited that our Cable Hill House project has been chosen by the AIA Portland to be one of seven houses included in the 2013 home tour: "Design Matters: A Tour of Exceptional Portland Homes".  The tour takes place on Saturday, October 12th.  Tickets are $40, and available from the AIA.

Before & After at the Skyline Residence

We're coming to the end of our work at the Skyline Residence, and it's incredible to look back and see the changes that have taken place since we began the process

Living Room

The living room was previously dominated by a stone-clad fireplace, which was high on the priority list of things the owners wanted to change. The first step was to strip the fireplace back to its concrete block structure.  Drawing on ideas we first explored at the Cable Hill House, we then built a sheet steel fire surround and hearth extension around it, with a walnut entertainment center above it.  This contains the audio/visual control boxes, and a sliding panel allows the tv to be hidden when not in use.  By removing the dropped ceiling, we were able to gain another 15" of ceiling height.  The carpet was replaced by new hickory floors, which run throughout the first floor of the house.

Kitchen

The kitchen remains in the same location in the house, but with a much more efficient layout and contemporary style.  The cabinets were custom made by Crownwood Construction, with exposed birch plywood frames and walnut panels. The island and main kitchen counter have a carrara marble countertop, which is nicely complemented by matte-white subway tiles at the backsplash.

Bar

We added a new bar where a redundant second fire place previously existed.  The bar employs the same language of walnut and plywood cabinets, with some tougher materials for durability. The countertops are a grey quartz from Cosmos, and the backsplashes and bar-front are made of the same sheet steel we used at the fireplace in the living room.  We made a break from the hickory floors used throughout the rest of the first floor, and changed to tile, to make an appropriate transition to the pool immediately outside.

Hall & stair

The hall was previously an unpleasant space, which felt dark and narrow.  Without changing the width of the hall, we able to create a much more inviting atmosphere. New openings along the wall dividing the hall from the public rooms increased the amount of natural lighting getting into the hall, which is supplemented by new can lighting. In the stair, we expanded on the approach we first employed at the Walsh residence by building a fir screen to filter the light coming into the space.  We demolished the partial height wall which was acting as a guardrail, and replaced it with a steel stair rail, which creates a stronger visual relationship between the two levels.  The previously utilitarian stairwell is now one of our favorite moments in the house.

Bathrooms

To avoid making major changes to plumbing and electrical system, we kept the existing layouts of the guest bathroom bathrooms, while making major changes to the finishes.  We continued the use of the walnut and plywood cabinets, but drew a visual distinction from the kitchen and bar areas by having the vanities float 12" off the floor, with tile running underneath them all the way to the wall.

Bedrooms

The layout of the bedrooms on the second floor generally worked well, so we only made minor alterations, primarily to create more closet space for the master suite. We installed new fir trim around the windows and ceiling beams, smoothed out and painted the walls, and installed new carpet throughout the second floor.

Westover Residence Renovations

drw design build is about to begin demolition on a new renovation project in the Northwest area of Portland.  The residence is beautiful and solidly built 1911 Tudor Home situated on a sloping site.  The new owners have hired drw to expand and update the kitchen, as well as other improvements through out the home.  The design will blend with the traditional elements of the home while providing modern amenities and generous work space.

Stair Rail Fabrication

As we near completion on the Skyline Residence, it's exciting to see the final items for the house being made. One of the last of these is a new steel guardrail for the existing stairwell.  The guardrail is being fabricated for us by Greg Forcum Art & Furniture, whose shop we paid a visit to this morning. The rail is looking great, and we will be excited to see it installed on-site later this week.

Skyline Residence Progress

The Skyline Residence is a project that we're really excited about, and it has been great to see it really come together in the last month. Since our last update, the cabinets and countertops have been installed, which has made a huge difference to the feel of the spaces.

Throughout the house, we have used a consistent language of walnut faced cabinets, with exposed birch plywood frames.  We enjoy the way this celebrates the construction of the cabinets, and provides a nice tonal contrast between the two species of wood.  By varying the countertop material, we have been able to give a degree of visual differentiation to different rooms: the kitchen uses Carrara marble; the bar and pantry a dark grey quartz; and the bathrooms use a white quartz.

 

Playing tetris with cabinets

Work is progressing well on our latest remodel, a new kitchen / pantry / mudroom / office near Council Crest.  For the last few months we have been busy demolishing walls and framing new ones; moving mechanical ducts and equipment; installing new plumbing and electrical; hanging sheetrock; and laying new floors.  It is an intense process, but always hugely rewarding to see a design leap off of the page and into reality.  While we were doing this work in Portland, the cabinet makers in Eugene were busy building the cabinets, which arrived on site this morning.

Everything we do is totally custom, and designed specifically for the clients we are working with. Early on in the design phase, we will concentrate on general issues, such as overall layout and locations for major appliances.  Once this is settled, we begin to get into more detail, and often work out what each and every drawer is going to be used for, and how large it needs to be as a consequence. While we are doing this, we are always thinking about how these cabinets will physically be built and transported to site. A good rule of thumb is that nothing should be longer than 8'-0", which is a standard dimension for a sheet of plywood. In at least one direction, the cabinets should be smaller than 30", so that they can fit through a standard width doorway.

Many banks of cabinets are larger than this though.  At the Fairmount Boulevard house, the kitchen island, for example, will be 18' long and 4' wide.  We therefore work out ways to break this down into smaller components, in a way that will look deliberate in its finished configuration. This is how the cabinets arrive on site, as seen in the photos above, before they are installed. As we have mentioned before, assembling these all on site is a bit like a game 'Tetris', and there's often little room to maneuver around the cabinets.  There is a lot of work involved in the install, particularly when everything is designed for tolerances to an 1/8".  The effort required, however, is worth it.